Tuesday, March 29, 2011

And on the Tenth Day

Here you see the aft fuel tank and the water tank partially installed. The stringer has not been re glassed in, you can see where it was cut out.

Here are the two forward water tanks. It used to be just 1 large tank but it had to be fabricated into tow smaller tanks to fit down the companionway. This is Randy, this guy worked really hard right along with Stash to get this project completed. He is from the Pacific Northwest.
This is Salvador the fiberglass man with his helper/daughter who is learning the trade from her father. He started and finished this job.




On Monday 3.14.2011 we motored Wand'rin Star over to Gatewoods after talking to Chris early that morning. He told us we could bring the boat on over but they probably would not get started till late Tuesday or Wednesday. We certainly wanted to have her there and ready to go the moment they could start on her so we got in high gear and within an hour we departed our slip at CC Marina at 0915 hours and had a nice sail over. While the Admiral took off all of our personal stuff and loaded it in the truck, I took down the Bimini/dodger, loosened the rigging and made other preparations to clear things out of the way so they could have easy access to the task at hand. We were done around 1400 so then we went to look for a place to stay the next 4 days. Fortunately we found a room in Rockport on the bay front that would do just fine, I could drive just 15 minutes and check on the progress of the tank installation and the Admiral had just a short drive to Port A for her birding. Tuesday I drove over to Gatewoods around 1400 hrs and went back to the boat to discover they had not started yet but just then Stash boarded the boat and begin to survey his next job. Stash was the lead man for the tank installation and over the course of the next several days we would work closely together to make sure we were both on the same page since this was a custom job and all the details would be engineered as work progressed. Our preliminary meeting pointed out the need for me to stay in close contact and check with them daily to work out the finer details of the installation. While Stash was the person who also removed two of the tanks, it had been a while and I knew I needed to help refresh his memory where certain wires and hoses lead to or where they should be re-connected.
Wednesday would be a full day for sure, with the help of his assistant Randy, they actually had three of the tanks in the boat by the end of the day. We met again that afternoon to sort out the next steps and agree on a few more details. By Thursday they had all four tanks in and partially plumbed. The tanks were foamed in place and they had to stop to let the foam set up harden. We checked in early Friday since this was the day the fiberglass man was supposed to re-glass the stringer we cut, make a platform for the Water muffler and put some tabbing on one of the water tanks. Unfortunately they lost their really good fiberglass man (never found out what happened to him) and so the hunt was on for Salvador. Salvador was our only hope in all of the Coastal Bend area. Luckily he lives next to Darrell & Debbie the owners of Gatewoods. He is known to do good work but he sometimes has difficulty finishing up a job??? The Admiral & I had to find new lodging since our hotel was booked for the next week due to Spring Break. We found a room over in Portland, it would have to do since it was the closest area available that had rooms. We booked three more nights since it was not clear when the fiberglass work would be completed and the tank installation could resume. Hooray,! on Saturday Salvador was there working on the glass work, I went and shook his hand and talked about the project. It was clear he knew exactly what to do and got right after it. Salvador took 2 1/2 days to complete. He painted his work and so that meant another day of downtime on Monday while the paint dried. Time to find another hotel. We were not at all impressed with our accommodations in Portland so we were lucky to find just the right place in Aransas Pass for another 4 nights. Tuesday Stash and Randy were in full stride as they began to tackle the details of completing the plumbing and wiring. About midday I realized the water tanks were good to go and I could go ahead and fill them with water to check out system and look for any leaks. Much better to do it here before we got the boat back to Corpus. We found 3 small leaks due to loose hose clamps and a leaking valve. Randy quickly fixed those. I checked with them Tuesday afternoon and it was clear they would need some of Wednesday to wire the tank gauges to the panel and fabricate a new pedestal for the primary bilge pump switch and discharge hose. I stayed on the boat after they left for the day and I checked all the connections for any problems. Since a lot of the connections would be under flooring with absolutely no access panels, I wanted to make sure there would be nothing overlooked. Wednesday morning I found they had already fabricated a new bilge pump switch pedestal. This was a very important detail as in the original installation the bilge pump only reached 1/2 down into the bilge area since the whole area around the tanks was filled in with foam. In this installation areas were purposely left open all the way down to the bottom of the bilge to allow for air circulation and a complete clearing of any fluids by the bilge pump. I knew we were at the end of this part of the project and we would soon have our boat back together. The Admiral had birding commitments in Port A on Wednesday so We made plans with Darrel to take the boat back to Corpus on Thursday morning. As Stash and Randy was cleaning up and completing the project I added 20 gallons of diesel to the fuel tank, began to put the Bimini/dodger back on and tighten the rigging for the trip back to Corpus. I had my little shop vac and went down and thoroughly vacuumed all I could. Then I washed every interior surface down to get all the dust out before the Admiral went down below. I scrubbed the decks to get off all the project dust and dirt and she was ready for us to put our truck load of personal stuff back aboard. We slept a little later Thursday Morning than intended but we did manage to get to Gatwoods by 0815 and by 0900 we were saying our goodbyes to the crew at Gatewoods and tossing off the lines. We Stopped at Conn Brown Harbor in Aransas Pass to fill the fuel tank. We had called him earlier to check in to make sure we could buy fuel from him. This is a commercial area with mostly offshore work boats, shrimpers and some tows, very few pleasure boats here. When we arrived there was a shrimper refueling but he was done quickly and it took two attempts but we moored up on the fuel dock. Cecil told me to make sure I did not spill a drop as the General Land Office was giving him a hard time. As I filled the tank Cecil stood by and read off the gallons in increments of 5. I knew we could take on 50 or so gallons but I stopped him at 45 since I did not want to risk dealing with a irate local and he had the best prices in the area and I knew his diesel was clean since he pumped so much of it. (clean diesel is very important, especially if you have brand new tanks!) The tide was coming in so we should be fighting the current all the way down the shrimp boat channel to Port Aransas. We were lucky if we made 5 knots, but as we turned the corner to Corpus at Port A we were making 8 all at 20,000 rpm. Yep, I could have stepped it up a bit but you know time is money and we have more time than money these days. As we motored back I began to mentally plan the installation of the flooring and all the many other projects that I had planned on completing since we had such full access to this part of the boat. I have a sack off parts just waiting to be installed and several more on order. I was biting at the bite to get started right away but I knew the Admiral would need some transition time to get back into the routine of living aboard especially after 10 days of strange hotel living and moving about so much. Friday we mostly decompressed, relaxed and just sorted things out. It was the weekend and lots of our weekender friends were arriving for a fun weekend.

Just a note for other Endeavour owners: The total project came in at $7K, about $2K more than we expected but while you have the boat that dissasembled you have to take advantage and correct/fix/upgrade as much as possible. We feel great about this project since we now know our boat throughly and are reaching the goal of getting her cruise ready by our November departure date. A yard in Kemah completed the same project for a Endeavour 43 owner from start to finish, and the bill was just over $16K so we figured we saved over 50% of the cost by doing as much of the work as possible ourselves.

1 comment:

  1. Hi

    Very complete blog on your new tanks. I ended up here from the Endeavour discussion forum when I started doing research when I found a Endeavour 42 for sale up in Washington. Maybe this wasn't your intention, but after reading all the reviews, blogs and posts about these tank problems, I won't be buying a Endeavour. I asked the broker if the tanks had ever been replaced, and he said they were AL and would never be replaced, blah, blah, blah. Any reason you didn't go with "plastic" tanks?

    Paul Bailey--Seattle (looking for cruiser).

    ReplyDelete